Mon–Sat 9:00–19:00 (UTC+8)
Category · 14 articles

人造树的防火、紫外线与合规标准

阻燃测试方法、紫外线与抗黄变验收标准,以及沙特、欧盟及美国项目的认证路径——专为需要在验收时提交测试报告证明的人员编写。

我们见过的大多数交付失败并非产品本身不合格,而是在错误的时间提交了错误的文件。在美国通过 NFPA 701 测试的材料,可能仍需向欧盟顾问提供 EN 13501-1 分类报告;而通过 SABER 通关的沙特项目,需要针对实际装柜批次出具符合性证书,而非仅针对样品。本指南说明了各项标准在何处适用、测试报告必须包含哪些内容,以及当客户询问叶片在迪拜经历三个夏天后外观如何时,应如何提供紫外线性能证明。

UV hours do not predict how an outdoor artificial tree behaves at 50 °C. Set the thermal rating, expansion allowance and ASTM evidence before you order.
Fire & UV Standards · 14 min read

50°C沙漠地区户外人造树的紫外线与耐热等级:需指定哪些参数,以及需要求提供哪些测试报告

紫外线照射时长无法预测户外人造树在50°C下的表现。在下单前需确定耐热等级、膨胀余量及 ASTM 测试报告。

Read article →
Shipping mode is set by the longest knocked-down piece, not by tree height. How a 40HQ, open-top, flat-rack and LCL compare on CBM, cost and lead time.
Fire & UV Standards · 13 min read

超过3米的人造树装柜:40HQ集装箱何时不再适用,以及开顶柜、平板柜与拼箱在报价前如何对比

运输方式取决于最长拆卸件的尺寸,而非人造树的高度。40HQ集装箱、开顶柜、平板柜与拼箱在体积、成本与交期方面的对比。

Read article →
How the leaf-to-branch joint and molded bark texture are specified on large artificial trees - pull-out loads, dressing rates and re-foliation cost.
Fire & UV Standards · 13 min read

大型人造树的叶片固定与模压树皮纹理:叶片与枝条连接结构如何影响落叶率与重新挂叶成本

大型人造树叶片与枝条连接结构及模压树皮纹理的规格说明——抗拉拔力、组装工时与重新挂叶成本。

Read article →
Build an artificial tree installation schedule that holds: door and lift clearances, hoisting windows, crew hours and the handover checks to record.
Fire & UV Standards · 12 min read

大型人造树安装进度:下单前规划现场通道、吊装窗口与移交顺序

制定可执行的人造树安装进度表:门洞与电梯净空、吊装窗口、施工人员工时及需记录的交付验收清单。

Read article →
Fiberglass vs foam trunks for 4-12 m artificial trees: shell wall, steel core sizing, moisture and repair, and which build survives Gulf projects.
Fire & UV Standards · 13 min read

大型人造树玻璃钢与泡沫树干对比:下单前确定外壳壁厚、骨架连续性与可修复性

4-12米人造树玻璃钢与泡沫树干对比:外壳壁厚、钢骨架规格、防潮与修复,以及哪种结构能经受海湾地区项目考验。

Read article →
Rooftop and podium trees can only be sized once the design wind speed, slab capacity and fixing method are documented. What to collect before you order.
Fire & UV Standards · 13 min read

屋顶及裙楼人造树风荷载输入项:下单前需确定的现场数据、结构签字与传力路径

屋顶及裙楼人造树的设计风速、楼板承载力与固定方式需先形成书面文件方可确定尺寸。下单前需收集的信息。

Read article →
Verify an NFPA 701 certificate for artificial foliage: which test method applies, what the report must name, and the batch checks to run before shipping.
Fire & UV Standards · 12 min read

人造树叶片的 NFPA 701 合规性:批准装柜前如何解读证书、测试方法与批次

核验人造树叶片的 NFPA 701 证书:适用何种测试方法、报告必须列明的内容,以及装柜前需执行的批次核查。

Read article →
Write a UV50+ spec for artificial palms at 50 °C: grey-scale limits, HALS content, salt-spray hours and the test evidence to demand from a supplier.
Fire & UV Standards · 13 min read

户外人造棕榈抗黄变验收标准:如何编制在50 °C下保持稳定的UV50+规格书

为 50 °C 环境下的人造棕榈树编写 UV50+ 规格:灰度等级限值、HALS 含量、盐雾测试小时数及需向供应商要求的测试证据。

Read article →
Roof anchor and base plate specification for large artificial trees: bolt grade, galvanizing, edge distance, C5 corrosion class and pull-out testing.
Fire & UV Standards · 13 min read

大型人造树屋顶锚固件与底板规格:下单前的螺栓等级、镀锌等级与抗拔测试

大型人造树屋顶锚固件与底板规格:螺栓等级、镀锌层、边距、C5 腐蚀等级与抗拔测试。

Read article →
Knock-down shipping for large artificial trees: joint design on the Q235 core, 40HQ CBM yield, torque specs and the on-site reassembly checks that matter.
Fire & UV Standards · 12 min read

大型人造树的拆装运输:节点设计、40HQ 装柜方数产出与保持分体钢骨架垂直度的现场复装检查

大型人造树的拆装运输:Q235 钢骨架的节点设计、40HQ 装柜方数产出、扭矩规格及关键的现场复装检查。

Read article →
SABER PCoC and SCoC, Civil Defence fire approval, NFPA 701 and EN 13501 evidence for artificial tree projects in Saudi Arabia and the UAE.
Fire & UV Standards · 12 min read

人造树 SABER 认证与民防阻燃等级规格:沙特与阿联酋项目在装柜前所需的合规卷宗

沙特阿拉伯与阿联酋人造树项目的 SABER PCoC 与 SCoC、民防阻燃审批、NFPA 701 与 EN 13501-1 证据。

Read article →
DWG shop drawings, approval cycles and installation scheduling for large artificial trees: what to issue at tender, and the lead times to build in.
Fire & UV Standards · 12 min read

大型人造树 DWG 生产加工图与安装进度表:下单前确定交货期、图纸审批与现场施工顺序

大型人造树施工图、审批周期与安装排期:招标阶段需提交的文件及应预留的生产周期

Read article →
Injection-molded PE vs silk foliage for commercial artificial trees: leaf density, fibreglass trunk build, fire rating and service life to spec.
Fire & UV Standards · 12 min read

商用仿真树叶材对比:注塑PE叶片与绸布叶片——下单前明确叶片材质、树干构造与使用寿命

商用仿真树叶材对比:注塑PE叶片与绸布叶片——叶片密度、玻璃钢树干构造、阻燃等级与设计使用寿命

Read article →
Wind load calculation for large artificial trees: how roof anchors, base plates and embedded fixings are sized at 45 m/s, and uplift numbers to specify.
Fire & UV Standards · 12 min read

大型人造树风荷载计算:沿海、屋顶及中庭项目的屋面锚固、底板及预埋件规格

大型人造树风荷载计算:45 m/s工况下屋面锚固件、底板与预埋件的选型及需明确的上拔力数据

Read article →
Explore the Catalogue

查找您所需的规格

按产品分类

  • 全部人造树系列
  • 地中海橄榄树
  • 大王棕
  • 榕属树冠树

按场地与市场

  • 按场地提供解决方案
  • 服务的行业
  • 按地区供货
  • 迪拜橄榄树

工程与采购

  • 买家常见问题与术语表
  • 定制工程与 OEM
  • 已安装项目